Kushal Udhyog Maufacturers of Dust Collectors, Cyclone Dust Collectors, Fabric Bag Dust Collectors, Cartridge Dust Collector Portable Abrasive Blaster, Abrsive Blasting Cabinets, Blast Room Systems, Abrasive Recovery Systems, Close Circuit Vacuum Blasting Machines, Custom Bulit Equipments, Spray Booths, Operators Safety Wears, Spares, Abrasives And Shots

KU – 16 OPEN KIT

‘KU – 16 OPEN KIT’ is a low cost equipment designed to blast clean components in tool rooms, machine shops, laboratories, job shops etc. to remove rust, scale, old paint, carbon, light burr and surface cleaning applications before applying paint or other coatings. It is best used for making decorative and handsome satin finish by sand blasting on glass and fancy handicraft articles. The abrasive used in the operation are Aluminium Oxide, Garnet, Glass Beads, Sand, Grit etc.

Technical Specifications :

1. Blast Gun		Model KU – S with 6mm I.D. Steel Nozzle and 2mm Steel Hardened Injector.
2. Abrasive Hose		20 mm (I.D.) Blast Hose, 2.5 Mtrs in Length
3. Abrasive Container		10 Ltrs. By Volume
4. Safety Wears		Googles, Hand Gloves and Respirator Mask (1 no. each) are provided with the equipment. Operator is however recommended to wear Abrasive Blaster Helmet Model ‘KU – 2’.
5. Air Requirement		20 cfm at 60 psig.
6. Recommended Abrsive Size		36 to 100 MESH

FEATURES :

1. Easy Installation		Just connect air line to the blast gun and start.
2. Low Air Consumption		0 cfm at 30 to 60 psig. 5 H.P. Air Compressor is sufficient.
3. Instant Start & Stop		: Blast gun is fitted with a brass pett cock for instant Start and Stop of blasting operation.
4. Low Cost Nozzle		Steel Hardened Nozzle, which is most economic and suitable for small job works. Tungsten Carbide / Boron Carbide Nozzles are also available at extra cost.
5. Use any type of Abrasives		Aluminium Oxide, Garnet, Glass Beads, Sand, Steel Grit, C.I. Grit etc in 36 MESH or finer can be used to have a finish of own choice.

KUS – 4030 :

A low cost foldable type desk model for touch up work of tiny components. It incorporate small pen type nozzle for Glass Bead Blast Cleaning and requires only 8 – 10 cfm of compressed air at 50 to 60 psi pressure. It is most suitable for fine touch up of jewelry or similar components and thus known as ‘Gold Smith’s Blast Cleaning Tool’.

The front of the cabinet is covered with transparent glass for visual inspection of job during cleaning process and the cleaning process is free from environmental pollution.